Product Categories
Contact Us

Taizhou Huayuan Metallurgical Machinery Co.,Ltd

Address: Taizhou of jiangsu province jiangyan area Zhang Dian CAI guan town industrial park

Tel: +86-523-86053989

Fax: +86-523-86053989

Phone: +8615195227247

Email: kimizhang@huayplant.com

News

How To Improve The Life Of The Radiant Tube

  How to improve the life of the radiant tube

  The radiant tube is the key equipment for the continuous annealing furnace of the galvanizing unit. It is used to radiate the strip steel to eliminate the internal stress of the strip and improve the plasticity. The purpose of the annealing is to reach the purpose of annealing. However, if the leakage tube is larger, The consequences, and even affect the normal operation of production. To prevent the radiation tube is burned to extend the life of the radiation tube, take some measures.

  1, adjust the combustion gas and combustion air combustion ratio, due to the atmosphere in the nitrogen atmosphere, radiant tube excessive oxygen will occur a strong nitriding oxidation, so that the radiation tube corrosion damage, so the combustion exhaust O2% content control in less than 2% The

  2, gas pressure control valve and air pressure control valve action should be sensitive, do not lag to ensure that the combustion gas pressure and air pressure stability, to ensure complete combustion of gas.

  3, exhaust exhaust fan speed smooth, reduce the combustion flame fluctuations.

  4, the combustion of air heat exchanger can not be leaked, to avoid the air was exhaust gas blown away, affecting the proportion of gas and air mixed combustion.

  5, the heat exchanger connection flange and seal can not be leaked, radiant tube to avoid the outside air into the air, as far as possible to improve the temperature of combustion air.

  6, if the conditions and funding permit, you should install a large heat exchanger, the use of emissions to the plant outside the waste heat (up to 390 ℃ for the first time preheated air, air into the burner tube heat exchanger after the second Preheat the air to raise the temperature of the combustion air.

  7, the radiation tube temperature> 400 ℃ (furnace temperature, is strictly prohibited to open the lid and remove the burner and heat exchanger, to avoid high temperature radiation tube cold air shrinkage caused by cracks.

  8, as far as possible to arrange the same heating needs of the strip production.

  9, the production as far as possible to maintain the uniformity of the working temperature, radiant tube to avoid the rapid ignition of the burner and stop the work of the burner to carry out purge cooling operation.